New: free Santa, snowman, tree, nutcracker and stocking charts →
Free chart

Learn / Cross stitch / Make a cross stitch bookmark

Cross stitch guide · updated 2026-11-10

How to make a cross stitch bookmark

Make a cross stitch bookmark by stitching a small motif within a narrow fabric panel, folding the raw edges onto the back and sewing on a thin felt cover. Plan the finished width and the fold allowance before cutting. The example here finishes about 2 by 7 inches, with a Tiny Garden tulip stitched on 14-count Aida and a soft, card-free back.

Example finishAbout 2 × 7 in, before any optional ribbon
Example Aida cut3 × 8 in, allowing ½ in to fold on every edge
Tulip chart11 × 14 stitches; about 0.79 × 1.00 in on 14-count
BackThin felt, sewn to the folded fabric margins

Choose a motif that fits the finished panel

For a bookmark, check the chart width before choosing a long strip of fabric. Our example uses the 11 by 14 stitch tulip from Tiny Garden. On 14-count Aida it is about 0.79 inches wide and 1 inch tall, leaving plain fabric around it on a 2-inch-wide finished bookmark.

Place one tulip near the top or repeat the same motif down the strip, marking each position before you begin. Those are layout choices using the existing chart, not an additional bookmark PDF. The Tiny Garden set also includes a bee, daisy and strawberry. The Tiny Cozy candle, at 7 by 12 stitches, is another narrow option.

Work out the cut size and folded edges

For this example, cut a 3 by 8 inch piece of Aida and reserve ½ inch along each of its four edges. Folding those margins onto the back leaves a 2 by 7 inch front. Keep every cross inside that finished area, with a little plain fabric between the design and the folds.

PartExample measurement
Aida before folding3 × 8 in
Fold allowance½ in at each edge
Finished frontAbout 2 × 7 in
Thin felt backingCut to sit just inside the folded front's edges

These are project choices, not a universal bookmark size. If you change the width or count, use stitches divided by fabric count to check motif fit. Mark the fold positions with temporary basting or a marking method you have tested on the fabric.

Drawn to scale: a 3 by 8 inch piece of Aida with a half inch margin band on all four sides; the dashed fold lines leave a 2 by 7 inch front with the motif inside. On the back, the folded margins are covered by felt sewn on with small stitches through the folds only.Fold and back a bookmarkDrawn to scale: 3 × 8 in Aida, ½ in folded to the back on every side, felt sewn over the back.1Plan the front3 in8 infront2 × 7 in½ in foldKeep the motif inside the fold lines. The foldsleave a 2 × 7 in front.2Sew the felt backfeltfoldededgeback viewLay felt over the folds and raw edges. Stitchthrough the folds only, never the front.
Drawn to scale: a 3 by 8 inch piece of Aida with a half inch margin band on all four sides; the dashed fold lines leave a 2 by 7 inch front with the motif inside. On the back, the folded margins are covered by felt sewn on with small stitches through the folds only.Fold and back a bookmarkDrawn to scale: 3 × 8 in Aida, ½ in folded to theback on every side, felt sewn over the back.1Plan the front3 in8 infront2 × 7 in½ in foldKeep the motif inside the fold lines. The folds leavea 2 × 7 in front.2Sew the felt backfeltfoldededgeback viewLay felt over the folds and raw edges. Stitchthrough the folds only, never the front.
A 3 by 8 inch Aida panel with ½ inch folded on each side makes a front about 2 by 7 inches. Felt covers the raw edges on the back.

Stitch and prepare the fabric

Use the free motif chart's symbol key and stitch at your planned position. Keep the back smooth: secure ends under nearby stitches and avoid long carries across unstitched areas. The knot-free starting guide helps keep a flat back.

Once the stitching is complete, follow our washing and pressing guide if the materials permit it. Let it dry fully. Press or finger-crease the planned folds, keeping heat within the materials' care limits. Check the finished front before you trim any excess at the corners.

Fold, back and sew the bookmark

Fold the two long margins to the reverse, then fold the top and bottom margins. Tuck the corners neatly so they do not project beyond the front. Baste the folded margins in place if needed. Do not trim into the front panel or its stitches.

Lay a thin felt rectangle over the reverse, just inside the finished edges. Use small whip stitches or slip stitches to catch the felt edge and the folded Aida margin beneath it. Work around the whole bookmark, checking that your needle does not emerge through the visible front. Secure the thread under the back finishing stitches.

A thin felt back keeps the bookmark flexible. Thick padding, card and raised embellishments add bulk between a book's pages. For an optional ribbon, tuck one end under the top felt edge and sew it securely to the folded margin before closing that edge.

Check the finish before putting it in a book

Check for exposed raw edges, loose thread tails and corners that could catch on pages. The bookmark should lie reasonably flat without forcing the book closed. If a corner is bulky, unpick a little of the backing seam, rearrange the folds and sew it again.

A design too wide for your strip may work better as a hoop display or framed piece. Find more small motifs in Fineway's mini charts, and return to the cross stitch learning hub for chart-reading and fabric help.

Make the felt-backed bookmark

  1. Plan and cut For the example, cut Aida 3 by 8 inches and mark a ½-inch fold allowance on every edge. Keep the motif inside the resulting 2 by 7 inch front.
  2. Stitch the motif Use the existing Tiny Garden tulip chart, placing it within the marked front. Keep thread ends secure and the reverse flat.
  3. Prepare and fold Clean and press only as the materials permit. Once fully dry, fold long edges, then short edges to the back, and arrange the corners neatly.
  4. Fit the felt Cut thin felt to sit just inside the folded front's edges. It should hide the raw edges without showing from the front.
  5. Sew and check Sew the felt to the folded margins with small stitches. Check all edges, secure the finishing thread and make sure no needle or pin remains in the bookmark.

Questions

What fabric should I use for a cross stitch bookmark?

Aida is easy to count and fold; the worked example uses 14-count Aida. Choose the count by checking the motif's finished width and leave extra fabric for your chosen edge finish.

How do I stop a cross stitch bookmark fraying?

In this method, fold every raw Aida edge to the reverse and cover those edges with a sewn felt back. Keep the perimeter seam secure and avoid leaving raw corners exposed.

Does a cross stitch bookmark need card inside?

No. This version has a folded fabric front and a thin felt back. It stays flexible and avoids a stiff card insert between book pages.

Can I make a cross stitch bookmark without glue?

Yes. Baste the folds if needed, then sew the felt backing to the folded fabric margins with small whip stitches or slip stitches. Secure an optional ribbon with sewing too.