New: free Santa, snowman, tree, nutcracker and stocking charts →
Free chart

Learn / Cross stitch / Finish cross stitch in a hoop

Cross stitch guide · updated 2026-11-10

How to finish cross stitch in a hoop

To finish cross stitch in a display hoop, center the clean, dry fabric, tighten the hoop without distorting the weave, and leave about 1½ inches of fabric around the outside. Sew a running stitch near the cut edge, gather the margin onto the back and tie it securely. Cover the gathered fabric with a felt circle sewn to the folded fabric, keeping the front clear of your finishing stitches.

FinishGathered fabric with a sewn felt back
Fabric marginAbout 1½ in outside the hoop for this method
TensionSmooth, with the fabric grid still square
AlternativeLace over board for a finish without a hoop

Choose the display hoop before trimming

A hoop is both the frame and the support in this finish. Choose one that leaves a pleasing fabric border around your motif. Try it over the stitched piece, including any lettering, before deciding the size. The hoop you used for stitching does not have to be the one you display.

Gather a smooth hoop, felt, strong sewing thread or floss (stranded cotton), a needle and fabric scissors. The felt should cover the back of the inner ring. If the fabric has already been cut close, test whether it will gather before trimming any more; a different backing or board-mounted frame may work better.

Prepare the fabric and felt

Use the wash and press instructions only if every material allows them. Let the piece dry completely. Before putting it back into the hoop, trace around the outside of the inner ring onto the felt and cut that circle. Test it against the back and adjust if necessary.

Place the dry stitching face up over the inner ring. Fit the outer ring with its screw at the top, then adjust the design until it is centered. Tighten gradually while keeping the fabric grain straight. Stop if the crosses or the grid become stretched.

Gather the margin onto the back

With the placement final, trim the fabric in a circle about 1½ inches outside the hoop. This is a working allowance for the gathered-back method, not a line measured from the edge of the stitched motif. Keep the scissors clear of the design.

Using strong thread, sew a running stitch around the margin about ¼ inch in from its raw edge. Leave both thread ends free. Pull them gently and evenly so the fabric folds over the hoop towards the center. Arrange the gathers until they lie flat, then tie the ends securely.

This knot belongs to the separate finishing thread on the back. For starting the actual cross stitches, see starting cross stitch without a knot.

Back construction of a hoop: keep a 1½ inch fabric margin outside the hoop with a running stitch a quarter inch inside the cut edge; pull the running stitch to gather the margin flat to the back and tie it; then sew a felt circle over the gathers with small stitches into the folded fabric.A gathered hoop backBack of the hoop, in three steps.1Keep a margin1½ inrunningstitchTrim 1½ in outside the hoop.Sew a running stitch ¼ ininside the cut edge.2Gather and tiepull tight,then tiePull the stitch up evenly so themargin folds flat to the back,then tie off.3Cover with feltfeltSew felt over the gathers,catching the folded marginonly.
Back construction of a hoop: keep a 1½ inch fabric margin outside the hoop with a running stitch a quarter inch inside the cut edge; pull the running stitch to gather the margin flat to the back and tie it; then sew a felt circle over the gathers with small stitches into the folded fabric.A gathered hoop backBack of the hoop, in three steps.1Keep a margin1½ inrunningstitchTrim 1½ in outside the hoop. Sew a running stitch¼ in inside the cut edge.2Gather and tiepull tight,then tiePull the stitch up evenly so the margin folds flat tothe back, then tie off.3Cover with feltfeltSew felt over the gathers, catching the foldedmargin only.
Back view: leave a margin, gather it inside the ring, then sew felt to the folded fabric. The circular guide is a gathering line, not a needle-direction arrow.

Sew on the felt cover

Place the felt circle over the gathered fabric. With small whip stitches, attach its edge to the folded fabric margin. Catch only a little of that folded fabric on each stitch; do not sew through to the visible front. Secure the thread under the finishing stitches when you come back to the start.

The felt hides loose ends and makes the back tidy. It is optional if you prefer to leave the gathers visible. A sewn back can be unpicked if you need to reframe later, though trimmed fabric will still limit the options. Add a hanging ribbon around the hoop screw if you want one, keeping it out of the stitched design.

Finish without a hoop, or choose a small practice chart

To finish cross stitch without a hoop, lace it over mounting board for a picture frame, or make a folded and backed bookmark. Do not use the circular cutting instructions for those finishes: each needs a different fabric allowance.

The Tiny Woodland mushroom is 11 by 11 stitches, while the Tiny Garden daisy is 13 by 13. Both leave room to experiment with a visible border in a small hoop. Check the chart and your chosen fabric count before buying the display hoop. More starting help is in the cross stitch hub.

Finish the hoop back

  1. Prepare and center Prepare the fabric as its materials allow and let it dry. Trace the inner ring onto felt, then center the stitching in the hoop.
  2. Set the tension Tighten the screw gradually. Keep the weave square and the motif smooth before making any cuts.
  3. Leave the margin Cut a circle of fabric about 1½ inches outside the hoop. Check the distance from the hoop, not from the design.
  4. Gather and secure Run a gathering stitch about ¼ inch inside the cut edge. Pull the ends evenly, settle the gathers onto the back and tie securely.
  5. Cover the back Whip stitch the felt to the folded fabric, catching only the back layers. Check the front as you work so no finishing stitches show.

Questions

How do I cover the back of a cross stitch hoop?

Gather the spare fabric onto the back, then sew on a felt circle cut to cover the inner ring. Attach it to the folded fabric without catching the visible front.

Do I need glue to finish cross stitch in a hoop?

No. A gathering thread holds the fabric margin on the back and small whip stitches hold the felt cover. This guide uses that sewn method.

How much fabric should I leave outside the hoop?

For this gathered-back method, leave about 1½ inches outside the hoop. Check the hoop size and fabric before cutting; a short margin may need a different finishing method.

How can I finish cross stitch without a hoop?

For a flat display, fold the fabric around a suitable mounting board and lace opposite margins together on the back, then fit it into a picture frame. A small motif can also be made into a backed bookmark.