New: free Santa, snowman, tree, nutcracker and stocking charts →
Free chart

Learn / Needlepoint / Start and end a thread

Needlepoint guide · updated 2026-11-06

How to start and end a needlepoint thread

Don't leave knots on the back. Start with a waste knot: knot the end, go down from the front about an inch ahead along your stitching line, and stitch towards the knot so your stitches cover the tail on the back; then snip the knot. To end, run the needle under about six or seven stitches on the back and trim.

StartWaste knot about 1 in ahead, in the stitching path
ThenStitch over the tail on the back, snip the knot
EndWeave under 6 to 7 back stitches, trim
Thread lengthAbout 18 in
Later threadsWeave the new end under existing back stitches

Why no knots

A knot on the back makes a lump that shows through once the piece is framed, blocked or made into an ornament. Knots can also work loose and pull through the canvas. Covering the tails with stitches holds the thread just as well and keeps the back flat.

The waste knot (in the path)

This is the usual way to start the very first thread, when there are no stitches yet to anchor into.

  1. Tie a small knot in the end of the thread.
  2. From the front, go down about an inch away, on the line you are about to stitch. The knot sits on the front.
  3. Come up where your first stitch starts and stitch towards the knot. On the back, each stitch catches the tail.
  4. When you reach the knot, pull it up and snip it close to the canvas.

Work towards the knot, not away from it, or the tail won't be covered.

How to Start a Needlepoint Thread the Right Way (& The Waste Knot) · video by Serendipity Needleworks on YouTube. The waste knot, start to snip, in under two minutes.Loads from YouTube only when you press play.

The away waste knot

If your stitching path doesn't pass over the knot, put it further away, outside the area you are stitching. When the area is done, snip the knot, thread the loose tail back onto the needle and weave it under stitches on the back.

Ending a thread

Stop with about 3 to 4 inches of thread left. On the back, slide the needle under six or seven stitches you've already made, then trim close. If you can, weave under stitches of the same color so a dark tail doesn't shadow through a light area.

Once you have stitches on the canvas, start new threads the same way: weave the new end under a few back stitches nearby, then come up and carry on. No knot needed.

Quick version

  1. Cut 18 in Longer lengths wear thin as they pass through the canvas.
  2. Knot and go in ahead Knot the end and go down from the front about an inch along the line you'll stitch.
  3. Stitch over the tail Work towards the knot so the tail is caught on the back, then snip the knot.
  4. Weave to finish Run the needle under six or seven back stitches and trim.

Questions

Do you knot the end of needlepoint thread?

Not permanently. Use a waste knot that you snip off once the tail is stitched over, so nothing is left on the back.

How do I start a thread for needlepoint?

With a waste knot for the first thread. After that, weave the new end under a few stitches on the back.

How to finish off a needlepoint thread?

Run the needle under about six or seven stitches on the back and trim the end close.

How long should a needlepoint thread be?

About 18 inches. Longer threads fray and twist.