New: free Santa, snowman, tree, nutcracker and stocking charts →
Free chart

Learn / Needlepoint / How to finish a needlepoint stocking

Needlepoint guide · updated 2026-11-17

How to finish a needlepoint stocking

Block the stitched stocking, trace its last stitched row onto paper and add 1/2 in of seam allowance. Sew the canvas to a velvet or velveteen back with right sides together and the top open, then clip the curves and turn it. Sew a lining the same shape, slip the stocking inside it with a hanging loop between the layers, and sew around the top.

Seam allowance1/2 in outside the last stitched row
Back fabricVelveteen or velvet
Hanging loopTop corner on the heel side, caught in the seam

Sizes for our free stocking charts

Our three free needlepoint stockings share one shape: 79 × 150 stitches. The top 12 rows chart a small loop above the cuff, so the stocking itself is 75 × 138 stitches. Inches = stitches ÷ mesh.

MeshStocking shapeBack piece with 1/2 in allowanceCanvas to start with
135.8 × 10.6 in6.8 × 11.6 in12.1 × 17.5 in
145.4 × 9.9 in6.4 × 10.9 in11.6 × 16.7 in
184.2 × 7.7 in5.2 × 8.7 in10.4 × 14.3 in

You need one back piece and two lining pieces of that size. Check other meshes in the canvas size tool.

Block it before you cut

Tent stitch pulls a long piece like a stocking out of square. Mist the canvas with water, pin it square on a board through the bare margin and leave it until it is completely dry. Never trim the canvas before blocking: the pins need that margin.

Trace the template only after the canvas is dry and square. The outline you draw has to be the squared shape, or the back and lining will be cut crooked too.

Draw a sewing template from the stitching

Our free stocking charts don't include a sewing template. The outline on the chart is the stitched picture, not a cutting line, so you make the template from your own blocked canvas.

  1. Lay the blocked canvas face up on paper and trace the outer edge of the last stitched row. That is the sewing line.
  2. Draw a second line 1/2 in outside it. That is the cut line: about 6 to 7 canvas threads on 13 mesh, 9 on 18 mesh.
  3. Cut the paper on the outer line and mark the heel side and the top.

Our stockings end in a dark one-stitch outline. Finishers recommend two waste rows past the design so the seam doesn't eat into it. On our stockings, stitch them in the outline color so the edge stays dark. They add 4 stitches each way: about 0.3 in on 13 mesh and 0.2 in on 18 mesh.

The outline of our 79 by 150 stitch stocking chart, filled rose with its pale cuff. A dashed sewing line follows the last stitched row. A tinted band half an inch wide surrounds it, ending at a solid cut line. Short clips cut into the band at the heel, toe and instep. The top edge stays open, and a cord loop sits at the heel-side top corner.Draw a sewing templateOur stocking charts have no sewing pattern. Trace the last stitched row, then add the seamallowance.1234top stays open1Sewing line: trace the last stitched row; sew justinside it so no bare canvas shows.2Cut line: 1/2 in outside the sewing line: 6 to 7threads on 13 mesh, 9 on 18 mesh.3Clips: snip into the allowance at the heel, toeand instep, stopping short of the stitches.4Loop: a cord or ribbon loop at the top corner onthe heel side.
The outline of our 79 by 150 stitch stocking chart, filled rose with its pale cuff. A dashed sewing line follows the last stitched row. A tinted band half an inch wide surrounds it, ending at a solid cut line. Short clips cut into the band at the heel, toe and instep. The top edge stays open, and a cord loop sits at the heel-side top corner.Draw a sewing templateOur stocking charts have no sewing pattern. Tracethe last stitched row, then add the seam allowance.1234top stays open1Sewing line: trace the last stitched row; sewjust inside it so no bare canvas shows.2Cut line: 1/2 in outside the sewing line: 6 to 7threads on 13 mesh, 9 on 18 mesh.3Clips: snip into the allowance at the heel, toeand instep, stopping short of the stitches.4Loop: a cord or ribbon loop at the top corneron the heel side.
The sewing line follows the last stitched row of our 79 × 150 stocking; the cut line sits 1/2 in outside it.

Trim the canvas and sew the back

Machine stitch around the shape about 1/8 in outside the stitching to keep the canvas from unraveling. Then trim the canvas on your cut line.

For the back, velveteen and velvet are common choices. Lay the fabric right side up, set the trimmed canvas face down on it and cut the fabric to match. This way the back mirrors the front.

Sew the two together just inside the last stitched row, so no bare canvas shows on the front. Leave the top open. Clip the curves: snip into the allowance around the heel and toe, and always at the inside corner of the instep, stopping short of the seam. Turn it right side out and push the toe out gently with a pen.

Line it and add the hanging loop

Cut two lining pieces from the template with the fabric folded, so they mirror each other. Sew them with a seam about 1/8 in deeper than the stocking's, so the lining comes out slightly smaller and sits smoothly inside. Leave a 3 to 4 in gap in the side seam and keep the lining wrong side out.

Fold a length of cord or ribbon into a loop. Pin it at the top corner on the heel side, between the layers, with the loop hanging down inside and the ends at the raw edge.

Slide the stocking into the lining so the right sides face each other and the tops line up. Sew around the top through every layer. Pull the stocking out through the gap, sew the gap shut by hand and push the lining down inside. If you'd rather not machine the top, fold both top edges in and slip stitch the lining to the stocking by hand.

Three stocking outlines. A: the stitched stocking with its cuff, turned right side out. B: the lining, two pieces sewn into a bag with a gap left in the back seam. C: the stocking inside the lining with right sides together, tops level, a loop between the layers and a dashed sewing line around the top.Line the stocking: a bag inside a bagSew the outer stocking and the lining as two separate bags, then join them around the top.AOuter stockingCanvas and back fabric sewnright sides together, curvesclipped, turned right side out.BLiningopenTwo lining pieces sewn with aslightly wider seam. Leave 3 to4 in open; keep it wrong sideout.CStocking inside liningRight sides together, topslevel, loop between the layers.Sew around the top.Then pull everything out through the opening, sew it shut and push the lining inside.
Three stocking outlines. A: the stitched stocking with its cuff, turned right side out. B: the lining, two pieces sewn into a bag with a gap left in the back seam. C: the stocking inside the lining with right sides together, tops level, a loop between the layers and a dashed sewing line around the top.Line the stocking: a bag inside a bagSew the outer stocking and the lining as twoseparate bags, then join them around the top.AOuter stockingCanvas and back fabric sewnright sides together, curvesclipped, turned right side out.BLiningopenTwo lining pieces sewn with aslightly wider seam. Leave 3 to 4in open; keep it wrong side out.CStocking inside liningRight sides together, tops level,loop between the layers. Sewaround the top.Then pull everything out through the opening, sewit shut and push the lining inside.
Two bags: the stitched stocking turned right side out, then slipped into the lining with the loop between them.

The cuff and the name

On our charts the cuff is stitched into the canvas: a pale field 60 stitches wide and 17 rows tall, or 4.6 × 1.3 in on 13 mesh. So you don't need a separate fabric cuff. If you want one anyway, sew it as its pattern says, leave its top edge raw, slip it over the stocking and baste the raw edges together before the lining goes on.

The charted word NAME is a placeholder. Swap in a real name from our stocking alphabets and count it before you stitch: how to fit a name in the cuff.

The small loop in the chart's top 12 rows is drawn in stitches. To hang the stocking, use the cord loop sewn into the seam.

Questions

What fabric do you use to back a needlepoint stocking?

Velveteen or velvet are common backs. For the lining, use a proper lining fabric such as cupro-viscose.

How much seam allowance does a needlepoint stocking need?

Cut 1/2 in outside the last stitched row, and sew just inside that row so no bare canvas shows.

Where does the hanging loop go on a stocking?

At the top corner on the heel side, caught in the seam between the stocking and the lining.

Do you block a needlepoint stocking before finishing?

Yes. Block it square and let it dry completely before you trace the template or trim any canvas.

What size is a needlepoint stocking on 13 vs 18 mesh?

Our 79 × 150 stitch stocking chart is 6.1 × 11.5 in on 13 mesh and 4.4 × 8.3 in on 18 mesh.

Get the charts by email