Counted versus stamped cross stitch
In counted work, you choose the position of every cross by reading the chart. In stamped work, the design is marked on the fabric. The finished X-shaped stitch can look the same, but the way you locate it differs. Fineway's downloads are counted charts, not printed fabric.
Start with the cross stitch beginner guide for the basic supplies and stitch motion. This guide focuses on the counting that keeps a design in the right place.
Read cells, not the grid lines
A symbol sits inside a chart cell. Match it to the floss (stranded cotton) key and stitch the corresponding fabric square. The four corner holes locate that square; the grid lines are boundaries, not extra stitches. A bold ten-square division helps you count, but it does not add a gap to the design.
For a move across a row, mark the last completed cell and the next target cell. In the exercise below, cell 1 is stitched, cells 2 and 3 stay empty, and cell 4 is the next stitch. That is two empty squares between the crosses. Check the vertical position as well before making a diagonal move.
Use the chart-reading guide when you need help with symbols or page joins.
Choose a starting point you can verify
Fold the fabric gently in both directions to locate its center. Find the chart's center marks, then locate a nearby stitched cell. If the exact center is blank, count from it to that cell instead of filling the blank space.
Work a small connected patch before traveling elsewhere. A second completed feature gives you another reference: for example, check a window against both the wall beside it and the roof above it. If those two counts disagree, stop and resolve the mismatch.
Use the real chart dimensions
The cherry in Tiny Sweet is 11 by 11 chart squares. At 14 stitches per inch, its design box is 11 divided by 14: about 0.79 inches square. Blank cells inside that box still count towards placement. Add finishing and handling margins separately; the design size is not the fabric cut size.
Try the fabric size calculator for a larger chart. The Aida count guide explains why changing fabric count changes size without changing the chart.
Recover from a counting error
Return to the last point you can verify against the chart. Count across and down from there, then compare the outline of the completed patch. Undo misplaced stitches before building more work around them. Do not stretch a later section to compensate: an apparently small shift can move every detail that follows.
Practice on one motif from Tiny Garden or Tiny Woodland. Finish the small motif before combining several into a border. Our cross stitch tips covers thread twists and tension once the counting feels comfortable.
Start a small counted chart
- Read the notes and key Confirm the fabric, strand count and stitch types. Choose one small motif rather than the whole sheet.
- Check the design box Use its width and height in stitches to plan the fabric size, then allow space for your intended finish.
- Match the centers Locate the chart and fabric centers. Count to the nearest stitched cell if the center itself is blank.
- Build a checked patch Stitch a short connected section, comparing each new cell with completed stitches in both directions.
- Record your place Mark completed cells on a personal working copy and note the next starting point before putting the work away.
Questions
Is counted cross stitch different from regular cross stitch?
Counted describes how you place the stitches: you count from a separate chart onto gridded fabric. Cross stitch describes the X-shaped stitch. A stamped design puts the placement marks on the fabric instead.
Do blank squares count in cross stitch?
Yes. Count them when locating the next stitch, but leave them unstitched unless the chart instructions say otherwise. Skipping their space moves the next part of the design.
Do I count holes or squares on Aida?
Match each full chart cell to a fabric square. The corner holes show where the needle enters and leaves; the square between them is the stitch position.
Must I start counted cross stitch in the middle?
No, but the center is a useful reference. A corner start also works if you have measured the fabric margins and located the design corner accurately.